Electronic and optical properties of Sr3X2 (X=N,P, As,Sb and Bi) compounds: first principles study

ABSTRACT

Direct bandgap semiconductors are very essential to fulfil the demand for the advancement in optoelectronic devices. Therefore it is important to predict new potential candidates having such unique features. In current work, Sr₃X₂ (X=N, P, As, Sb and Bi) compounds have been reported for the first time by well trusted FP-APW+lo method. For the better prediction of the energy band gap, mBJ is used alongwith routine generalised gradient approximation (GGA). The results show small and direct energy band gaps at Γ-Γ symmetry points with magnitude in the range from 0.62?eV (Sr₃P₂) to zero energy band gap (Sr₃Bi₂). In partial density of state Sr-d state and X-p state are contributed in the band structure. The compounds show mostly covalent bonding nature. The frequecy dependent optical properties in the linear optical range are also investigated.     

Influence of solvent on solution processed Cu2ZnSnS4 nanocrystals and annealing induced changes in the optical,structural properties of CZTS film

The well-known quaternary Cu₂ZnSnS₄ (CZTS) chalcogenide thin films are playing an important role in modern technology. The CZTS nanocrystal were successfully prepared by solution method using water, ethylene glycol and ethylenediamine as different solvent. The pure phase material was used for thin film coating by thermal evaporation method. The prepared CZTS thin films were characterized by XRD, Raman spectroscopy, FESEM, XPS and FT-IR spectroscopy. The XRD and Raman spectroscopy analysis revealed the formation of polycrystalline CZTS thin film with tetragonal crystal structure after annealing at 450 ^°C. The oxidation state of the annealed film was studied by XPS. A direct band gap about 1.36 eV was estimated for the film from FT-IR studies, which is nearly close to the optimum value of band gap energy of CZTS materials for best solar cell efficiency. The CZTS annealed thin films are more suitable for using as a p-type absorber layer in a low-cost solar cell.     

Novel halogenated cyclopentasilylene-2,4-dienes via DFT

In view of immense importance of silylenes and the fact that their properties undergo significant changes on substitution with halogens, here, we have used B3LYP/6-311++G** level of theory to access the effects of 1–4 halogens (X = F, Cl, Br, and I) on four unprecedented sets of cyclopentasilylene-2,4-dienes; with the following formulas: SiC₄H₃X ( 1 _X ), SiC₄H₂X₂ ( 2 _X ), SiC₄HX₃ ( 3 _X ), and SiC₄X₄ ( 4 _X ). In going down from F to I, the singlet (s)-triplet (t) energy gap (ΔE_s-t, a possible indication of stability), and band gap (ΔE_H-L) decrease while nucleophilicity (N), chemical potential (μ), and proton affinity (PA) increase. The overall order of N, μ, and PA for each X is 2 _X > 1 _X > 3 _X > 4 _X . Precedence of 2 _X over 1 _X is attributed to the symmetric cross conjugation in the former. The highest and lowest N are shown by 2 _I and 4 _F . The trend of divalent angle () for each X is 4 _X > 1 _X > 3 _X > 2 _X . The results show that in going from electron withdrawing groups (EWGs) to electron donating groups (EDGs), the ΔE_s-t and ΔE_H-L decrease while N, μ, and PA increase. Also, rather high N of our scrutinized silylenes may suggest new promising ligands in organometallic chemistry.     

激光分子束外延方法生长的ZnO薄膜的发光特性

研究了不同温度和不同光激发强度下激光分子束外延方法生长的ZnO薄膜样品的发光性能,发现YAG脉冲激光激发,强度超过一定值时会在长波方向上出现一个新的发光峰,此峰可能起源于电子-空穴的复合。室温下氙灯激发的光谱中可以看到峰值位于381nm的近带边紫外发射峰和位于450nm的强的蓝绿带发射,根据光致发光激发光谱的特征给出了一个简单的蓝光发射模型。对比YAG脉冲激光激发和氙灯激发得到的实验光谱,我们认为不同的光谱特征和样品发光的激发机制有关,紫外峰发射需激发强度超过一定值才能观察到,而蓝带发射则在一定的激发强度下迅速饱和。     

介质折射率对一维三元光子晶体带隙的影响

利用光学传输矩阵法,数值模拟了一维二元、三元光子晶体的带隙结构,得出:三元光子晶体的主带隙略宽于二元光子晶体的主带隙;三元光子晶体的主带隙主要取决于最高折射率的介质和最低折射率的介质,而与居于两者之间的介质关系不大,并作出了相应的关系曲线。最后推导了三元光子晶体的色散关系。     

极化子导电到能带导电的转变

采用交流法测量大功率商用钛酸钡(BT)陶瓷加热器的电阻和加热功率随温度的变化关系.结果显示,BT陶瓷的电导特性在80℃附近出现了明显的转变,从低温时的极化子跳跃导电转变为高温时的能带导电,此时,电阻出现极小值,而加热功率出现极大值.     

一种基于GIS的选址问题及算法

本文考虑了选址区域内存在地理阻断情况下的一种基于GIS的选址问题.对单配送中心选址模型,以GIS返回的任意两点间的最短可行路径的长度作为修正距离函数,分析了目标函数在凸形选址区域上非凸非连续的性质.进一步,采用给出了一种近似搜索算法并通过一个实例计算与重心法进行了比较.     

平面火花隙三电极开关研制及性能测试

 研制了一种适用于平行板传输连接的平面火花隙三电极开关，开关正负电极为半圆形状，触发电极为细条状。将之替代立体式（半球形电极）火花隙三电极开关并应用于爆炸箔起爆装置中，装置回路参数将得以优化。实验测试了空气间隙为4.12， 3.14和2.2 mm的平面火花隙三电极开关的性能。结果表明，在开关间隙间距一定的情况下，随着电压的升高，开关间隙的放电时延和分散时间呈指数降低，开关电感小于15 nH；对于不同范围内的应用电压，使用不同间隙间距的开关，其分散时间不大于10 ns。该开关应用于较低充电电压（小于10 kV）的脉冲功率装置中，与立体式火花隙三电极开关相比，回路电感降低了约50 nH，放电周期缩短近1/3，峰值电流增加约1/3。     

The many proofs of an identity on the norm of oblique projections

Given an oblique projector P on a Hilbert space, i.e., an operator satisfying P ²=P, which is neither null nor the identity, it holds that ||P|| = ||I –P||. This useful equality, while not widely-known, has been proven repeatedly in the literature. Many published proofs are reviewed, and simpler ones are presented.     

Studying the process of ionization of hydrogen in conditions of its forced delivery to a porous nickel oxide electrode

The hydrogen ionization process is studied experimentally on an industrial sintered nickel oxide electrode in models of sealed nickel-metal hydride batteries. It is shown that the hydrogen ionization rates that are reached during overcharge by high current densities in conditions of forced gas delivery into the electrode pores (up to 40 mA cm^?2) exceed the self-discharge rate of a nickel-hydrogen battery by two orders of magnitude. Up to 70% of hydrogen delivered into the compact assembly block undergoes ionization during forced charge of models of sealed nickel-metal hydride batteries with a closed hydrogen cycle. Two independent methods (potentiostatic and manometric) are used to determine the relationship between rates of hydrogen ionization with the degree of the electrode filling with gas and perform estimation of the process intensity at a unit reaction surface. It is established that, in conditions of forced gas delivery, practically all the hydrogen oxidation current is generated at the surface of the nickel oxide electrode beneath thin films of an electrolyte solution at the rate of 4–5 mA cm^?2. It is shown that the hydrogen oxidation rate on a nickel oxide electrode filled in part by gas is independent of the electrode potential, probably because of a tangible contribution made by diffusion limitations to the overall hampering of the process.